Apple Watch Charging Dock

Simple, quick and easy to print. 

This dock works best with Apple watches that have two straps and not the single loop straps as the watch will need to lay flat on the desk.  Simply fill the dock with UK pennies, slide the charging puck into the top cover and snap everything together.

Additional details: 

• For best results you will need to fill the bottom half with 30 1p coins (UK) to act as a counterweight.
• There are no overhangs so you can print at any resolution, I’ve found that 0.3mm seems to be a good compromise between vertical quality and time.
• If you print in white PLA you may see through the dock as it will be slightly transparent due to the thickness of the walls.
• This print uses approximately 7m of filament.