Description
Level and finely tune your printer to perfection by printing this all important first layer. This great tool can be used to adjust your z-off set to less than a tenth of a millimetre!
The square is 200mm x 200mm x 0.1mm, the printing time is about an hour and a half in super fine quality mode, use filaments (1.75mm) heating recommendations.
More from this category
SDSBTOTO | Modal Receh WD Sultan
by SDSBTOTO
Siapa yang tidak suka bermain togel? Bagi sebagian orang, bermain togel adalah hobi yang menyenan...
Electric Guitar
by imprende
I designed this Electric Guitar body to be printed on an Ultimaker 2 and be assembled without the...
Iphone Stand
very easy to print !!!! G model but any other character available on demand !!!!! 3D PRINTIN...
SD Card Flash Drive Holder
by Gpasteve
SD Card/ Flash drive holder that can be mounted to a 3d printer, a desk or a shelf .
E3D V6 bowden Fan duct for Kossel
by dTom
Summary2 vents blow to hotendInstructionsbowden Fan : 45x12 ( Model : BFB04512HHA ) Layer high : ...
Apple Pencil with Smart Cover clips for iPad Pro
by vova_chmarak
Clips for iPad Pro with Smart Cover and apple pencil
Comments (0)
Sign in to leave a comment.
No comments yet. Be the first to comment!