Description
Summary
I had to make new ones for my diy prusa. Is printed with ABS at 0.3 layer and 20% infill, is much better than those i had.
Is ok but maybe i make some changes not for usabillity as for the look.
Instructions
20% Infill
0.3 Layer
Cura slicer
More from this category
Endoscope Mount for Ender 3, Ender 5, CR-10
by Robert Mech
I was amazed how few endoscope mounts were out there and how few were really good. Endoscopes wil...
7 ❤️
1 💬
0 ⬇️
Free
SDSBTOTO | Modal Receh WD Sultan
by SDSBTOTO
Siapa yang tidak suka bermain togel? Bagi sebagian orang, bermain togel adalah hobi yang menyenan...
0 ❤️
0 💬
1 ⬇️
Free
Bushing Test
by Zach Frew
Bushings printed in Durable Resin have smooth and low-friction movement over a 9.5...
12 ❤️
5 💬
0 ⬇️
Free
Pen Holder for Limited Grip (1)
Pen Holder for Limited Grip Holds pen either side and can be used for left or right handed people...
1 ❤️
1 💬
0 ⬇️
Free
Nokia 1020 Holder for Intruder C800
SummaryA way to use the GPS and maybe take some videos of the panorama. I hope that all will be o...
1 ❤️
1 💬
0 ⬇️
Free
Flexible covid ear saver (13 to 24 cm long)
by imakina
Flexible ear saver 13 to 23 cm long. Only 1 gram each piece.
1 ❤️
1 💬
0 ⬇️
Free
Comments (2)
Sign in to leave a comment.
Nice picture, I want to use one of these for a <a href="https://mechswitcher.com/most-silent-linear-switches/">best silent linear switch</a>. Please create a logo for my website, and I will be grateful.