Description
This is a Rep-Rap style CNC vacuum former design for Nema 17 motors and a DIY heater. Off the shelf electronics include Arduino Uno, TB6560 stepper drivers, and an Itead Nextion 320x240 LCD touchscreen.
Full 200x200 print area is required for the vacuum bed which also requires an entire roll of PLA plastic and approximately 35 hours to print! Most other pieces were made out of ABS for a little flexibility.
Additional non-3d printed parts needed:
- 2 - 12"x14.75" steel or aluminum sheets for frame
- 4 - 8mmx500mm linear rods
- 4 - LM8UU linear bearings
- 2 - Nema 17 stepper motors
- 2 - GT2 16 tooth gears
- 2m GT2 timing belt
- 1mmx5mm Neodimium magnet
- 1/4" case magnetic proximity switch
- 2 - 5v controlled relays
- 1 - 2000W AC PWM control
- DIY Heater Assembly
- 1 - solenoid valve
- 3/4" Watertight conduit fitting
- Misc screws, wires, junction boxes, switches
Arduino Uno and Nextion display firmware are available as well.
More from this category
Phidgets PH ORP 11300 Adapter Case Housing
by IOT_Guy
Enclosure for the Phidgets PCB assembly 11300 of the PH/ORP Probe/Sensor. Features: Slotted mo...
Iphone Stand
very easy to print !!!! G model but any other character available on demand !!!!! 3D PRINTIN...
SD Card Flash Drive Holder
by Gpasteve
SD Card/ Flash drive holder that can be mounted to a 3d printer, a desk or a shelf .
E3D V6 bowden Fan duct for Kossel
by dTom
Summary2 vents blow to hotendInstructionsbowden Fan : 45x12 ( Model : BFB04512HHA ) Layer high : ...
Apple Pencil with Smart Cover clips for iPad Pro
by vova_chmarak
Clips for iPad Pro with Smart Cover and apple pencil
Comments (2)
Sign in to leave a comment.
Good day. I see this purchase does not include the firmware for the arduino and LCD aswell as the schematic. Is this an optional add-on? and if so what is the cost?