Description
SummaryMade this to to quickly calibrate extruder steps. notch is 100mm from end. so I clip it on make a mark and remove it. Then run 100mm of filament. It is made for 3mm(2.85mm) filament diameter. Print SettingsPrinter Brand: LulzBotPrinter: TAZ 5Rafts: Doesn't MatterSupports: No
More from this category
SDSBTOTO | Modal Receh WD Sultan
by SDSBTOTO
Siapa yang tidak suka bermain togel? Bagi sebagian orang, bermain togel adalah hobi yang menyenan...
0 ❤️
0 💬
1 ⬇️
Free
MKS gLCD 12864 Case
by Patrick Li
MKS gLCD 12864 Case V3, Fix angle of bottom to 90 degree
0 ❤️
1 💬
0 ⬇️
$3.0
OpenRC Calibration Cube
by DanielNoree
Before you start printing the OpenRC F1 that uses pockets to fit the small M3 nuts and see if you...
12 ❤️
1 💬
0 ⬇️
Free
CluchCoCloneV2
by Froongia
Join us in the journey of redefining what's possible. ClutchCo: 3D printed perfection, designed f...
1 ❤️
0 💬
0 ⬇️
$10.0
vacuum pod per Biesse rover
by steveandsong
vacum pod per Biesse rover 346 e altri modelli
1 ❤️
1 💬
0 ⬇️
Free
Flexible covid ear saver (13 to 24 cm long)
by imakina
Flexible ear saver 13 to 23 cm long. Only 1 gram each piece.
1 ❤️
1 💬
0 ⬇️
Free
Comments (1)
Sign in to leave a comment.
No comments yet. Be the first to comment!