Triangular Iphone 6/6s Case

This is my first attempt at an iPhone 6/s case. It is a simple triangle design with some over layered bumpers that cover the entire edge of the phone.  

Note: I recommend increasing the infill settings at 100% to increase the strength of the iPhone case.

My Configurations Settings: (may vary since these are my settings )

Slicer: MatterControl

Printer: Wanhao Duplicator I3

infill setting: 100%

Layer Height: 0.1mm (0.2mm look  looks okay as well.)

Raft: Yes (but not recommended)

Print ETA Time: 4 Hours 35 Minutes

HeatBed: yes (not recommended )

--- Support 3D Creator ---

If you would like to help me create more cool things and remake stuff, or buy me coffee that would fuel my creativity to do so, you can by clicking here .