Batman Phone Stand

Show your Batman pride with this Batman phone stand! This two piece phone stand is very easy to print, because there aren't any supports or bridges to worry about!

I printed this (with PLA) with these settings: 

Speed: 40 mm/sec

Infill: 20%, honeycomb pattern

Layers: 0.3 mm each, 0.4 mm for first

Bridging or supports: None!

Filament settings will vary by filament. I use Inland's red and yellow PLA filament. Here are the settings I used:

Temperature: 220 C

Bed temperature: 57 C

Post-printing:

My printer can't print very high quality, so I had to use a finishing tool to smooth out edges and make some of the holes a little bigger. I bought a really cheap one, but does the job well: http://www.modifi3d.co.uk/

***The phone used for this print was an iPhone 6, so I don't know if larger phones can fit. If they don't (which they probably won't), just scale the file larger, maybe 105%.