Description
My first Raspberry Pi Zero case. Support the new version that comes with a camera port. It can be printed in one piece and no assembly is required. This is a low profile version. Which means it will only hold the PI Zero itself without any jumper and HAT on it. I'll publish more version later. So do follow this creation if you need bigger versions that can hold the GPIO jumpers, camera or even HAT.
More from this category
SD Card Flash Drive Holder
by Gpasteve
SD Card/ Flash drive holder that can be mounted to a 3d printer, a desk or a shelf .
Apple Pencil with Smart Cover clips for iPad Pro
by vova_chmarak
Clips for iPad Pro with Smart Cover and apple pencil
Flexible covid ear saver (13 to 24 cm long)
by imakina
Flexible ear saver 13 to 23 cm long. Only 1 gram each piece.
Arduino Pro Mini Holder
by dTom
SummaryUpdate V3, More secure to hold the Pro mini For Plotclock on Note 2 (http://www.thingivers...
Aluhotend fan duct
by misan
SummaryFor a 25mm fan. Tap the the holes with M3 and use M3x16mm screws to fix the fan. Press th...
Comments (12)
Sign in to leave a comment.
Bathroom Cabinet Collection Mowoen - Bồn tắm nhập khẩu https://mowoen.vn/phong-tam/tu-lavabo/
Bathtub Collection Mowoen - Bồn tắm nhập khẩu https://mowoen.vn/phong-tam/bon-tam/
https://kluger.vn/voi-rua-bat - Kluger kitchen faucet - Vòi rửa bát Kluger nhập khẩu
https://kluger.vn/chau-rua-bat - Kluger kitchen sink - Chậu rửa bát Kluger nhập khẩu
https://kluger.vn - Kluger All you need
very nice design, but completely unusable as the 2 halves are fused together. :(
it looks good,and if somebody want to do print it,please contact us, we can help you print it in a short time.and also spray painting on the surafce as you need.we are the SLA 3D printing manufacturer, please email me at gaojiemodelsales01@163.com Debbie
Printed perfectly. Excellent job. Liked it so much had to print a 2nd one for my other pi zero as I didn't like it's case near as much. 0.4mm extruder using cura's "normal quality setting of 1mm".
Glad to hear you like it so much. Thanks a lot.
I printed this and it looked good but the two pieces fused together. How do I avoid this?
Hi, first try rotate the cover along the hinge slower. It may get stick together at first but you should be able separate them without breaking it. If the 2 pieces get fused together at the hinge. You may need to re-print it with a better printing resolution. I'll suggest a setting with 0.4 mm nozzle opening or even less. Hope this help.