Description
ertical direct extruder for 1.75mm filament(for 3mm just use drill bit).
Changes:
- Idler clamp is M4 bolt (length is depend from spring length), bigger hole for nut and bolt
- supports is already made (idler and fan)
- groove for motor mounting screws
All parts for build it together is compatible with this -> http://www.ebay.com/itm/Greg-Wade-Reloaded-Extruder-3D-Printer-Screws-Bearings-Springs-Hobbed-Bolts-/161674059456 kit
YouTube video printing:
More from this category
Smart LCD Case Stand Alone version
A stand alone LCD case for the RepRap Smart LCD with SdCard reader
7 ❤️
2 💬
1 ⬇️
Free
Mobile repair tools
by jjgolff
Herramientas de apoyo para la reparación de los móviles. Impresora 3d 220 x 220 x 220. PLA....
8 ❤️
1 💬
0 ⬇️
Free
SD Card Flash Drive Holder
by Gpasteve
SD Card/ Flash drive holder that can be mounted to a 3d printer, a desk or a shelf .
0 ❤️
1 💬
0 ⬇️
$0.5
Apple Pencil with Smart Cover clips for iPad Pro
by vova_chmarak
Clips for iPad Pro with Smart Cover and apple pencil
1 ❤️
1 💬
0 ⬇️
Free
Flexible covid ear saver (13 to 24 cm long)
by imakina
Flexible ear saver 13 to 23 cm long. Only 1 gram each piece.
1 ❤️
1 💬
0 ⬇️
Free
Comments (4)
Sign in to leave a comment.
Thanks, I did find that our later and it was OK.
Your Printed version of your body does not fit with the Idler, Is there a correction on this?
it 100% fit, I also tested it. If do not fit in you case, then on the body where ider is mounted, cut support material and then will fit.