Replacement Lever - Water Fountain / Dispenser

Stock standard replacement levers usually cost $70 Aud apparently (or so says the maintenance guy at work who seems very happy to have cheap replacements).

Printed on an Ultimaker 2 Extended +  |  0.4mm Nozzle |   Sliced with Cura slicing software

Update 12 January 2018: model now solid  (no multiple shells) due to some slicing software not being able to handle multiple shells.

Print settings:

Pre-Modeled Custom Supports (turn off supports in your slicing software)

Layer Height: 0.1 mm 

Print speed: 50mm/s - Top/Bottom Speed 20mm/s - Travel Speed 120mm/s - Initial Layer Speed 20mm/s

In-Fill Density : 75%    -    In-Fill Pattern : Lines

Build Plate Temp: 60Deg/C  |  printed in ColorFabb PLA / PLH  @212Deg/C.

Bed/Platform Adhesion dependent on material :

-  PLA = Print on clean glass no added adhesives.

-  Other Materials = ? Haven't had time to practice/experiment printing w/other materials.

Boolean Operands were employed in the creation of this model.

Please remember material shrinkage will vary depending on material, brand and colour.

If you like any of my designs please show your support by sharing them with your followers on Twitter #3dprinting and upload pictures of your prints. Happy printing.

D3V!rum3tM^ch!n^ @DVirumEtMachina