Description
Printed on a Stratasys uPrint SE Plus at a 0.25mm resolution. Printed on Low Density (+-50% Infill). Can be printed reasonably well on a cheaper printer like a MakerBot Replicator 2x but take in mind that support material would most likely be required. Even after that you might still need to do some work on your printed rhino.
More from this category
a little frog
by ogolum
I creat this frog, because i love frogs. I scaled it 15x, Print Settings: 0.2mm, no raft, no Supp...
4 ❤️
1 💬
0 ⬇️
Free
Jack Skellington Articulated Hand Extender
by dave_long
https://www.youtube.com/watch?... This is my original design based on my modular hand, skinned a...
33 ❤️
2 💬
0 ⬇️
Free
Comments (1)
Sign in to leave a comment.
No comments yet. Be the first to comment!