Description
Benjamin's lunar rover is made to go with Benjamin's rocket which is available on this site. Search for "BENJAMIN'S ROCKET.
The astronaut file is included in this group. The astronauts should be printed in PLA using either .1 or .2 layer height and two to three shells. I used 20% infill. It should be printed standing up with the feet on the bed. no supports are required but the cooling fan should be on for the entire print as there are a number of small overhangs. If available in your slicing software use inside-out printing.
The lunar rover can hook up to as many trailers as you want to make!
The center of the wheels can be made using soft filament or you can use rubber square O-rings for traction on smooth floors. The trailers are made to hold the water and oxygen tanks and containers which are available free on this site. Search for "BENJAMIN'S SUPPLY TANKS, CONSOLES AND CONTAINERS".
More from this category
Explore Making: VeggieMake
Students are given a VeggieMake (a toy that turns produce into a cute character)– but the pieces ...
desk corn hole
by Will Shuler
this was a fun design with a lot of effort for the table and return system
Fidget spinner bow tie style
by 3deyedoc
I had a request for a bow tie shaped spinner and this was the result. I was able to print this on...
Dubai Call Girls Service 0525382202 Indian Call Girls in Dubai
by voyal73886
Dubai Call Girls Service 0525382202 Ind
RED HOOD CHEST EMBLEM-JL TEXTURE
by DEVING
RED HOOD CHEST EMBLEM-JL TEXTURE 3D print model Red hood chest emblem for cosplay... textured li...
Comments (7)
Sign in to leave a comment.
Hi Chris, the porthole measures 75mm, could you expand it to 80mm as the porthole cover does not fit in and 5mm is too much to trim.
Hi Totalitarian, I will look into this after work today.
Support needed for the cab windows?
Hi totalitarian, Yes the cab front is the only cab part that requires supports. I added two photographs along with the vehicle photos at the top of the page showing the supports that I used. The inlayed number 3 on the front did not require supports. If you choose to print the one-piece cab then all of the window openings will require supports.