Description
Dock for the iPhone 6 with the cavities to use the original charging cable and connect an audio jack. Made on three parts and then glued together. Soon I will post a new version with some design improvments.
More from this category
SDSBTOTO | Modal Receh WD Sultan
by SDSBTOTO
Siapa yang tidak suka bermain togel? Bagi sebagian orang, bermain togel adalah hobi yang menyenan...
MKS gLCD 12864 Case
by Patrick Li
MKS gLCD 12864 Case V3, Fix angle of bottom to 90 degree
Post-It Note and Pencil Holder
by LogixNinja08
A MLG post it holder that holds ... you guessed it ... cocain- I mean post its. ...
OpenRC Calibration Cube
by DanielNoree
Before you start printing the OpenRC F1 that uses pockets to fit the small M3 nuts and see if you...
CluchCoCloneV2
by Froongia
Join us in the journey of redefining what's possible. ClutchCo: 3D printed perfection, designed f...
vacuum pod per Biesse rover
by steveandsong
vacum pod per Biesse rover 346 e altri modelli
Comments (2)
Sign in to leave a comment.
As anyone printed? Any improvement suggestions?