
Description
Summary
This cup is a replicate of a Tuberware coffee cup.
Instructions
It takes about 2.5 hours to print at the following slice:
2 perimeters
.5mm nozzle
.3 layer height
.3 infill
80mm/sec
Clean up after printing.
To make it watertight, coat inside and out with:
SCIGRIP #2354 ABS solvent cement, and let dry for 1 hour.
Test by filling with water, place it on a paper towel and check it in 5 minutes. If it leaks re-coat with the solvent cement. Re-fill with water and leave it overnight. A few of my cups were coated three times.
I have printed over 20 cups using ABS filament extruded on the Lyman Filament Extruder V3, for Xmas stocking stuffers.
Comments (1)
Sign in to leave a comment.
No comments yet. Be the first to comment!