













Description
This is a Glidecam inspired by the Devin Graham signature series.
Features:
- Adjustable head
- Movable gimbal
- Quick release plate
- adjustable lenght
- Extendable base plate (if lasercut)
The Parts are 3D printed, but you will need some other part:
- 2 bearing (for in the arm)
- Outer diameter: 8 mm
- Inner diameter: 5 mm
- 2 bearing (for the grip you will hold
- Inner diameter: 8 mm
- Outer diameter: 15 mm
- 1 bearing (for one the tubes)
- Inner diameter: 25 mm
- Outer diameter: 37 mm
- 20 mm diameter aluminium tube
- 15 mm diameter aluminium tube
- 110 mm long 5 mm thread + 1 normal nut and 1 seal nut ( for adjusting the head)
- 70 mm long 6 mm thread + 1 normal nut and 1 seal nut ( for adjusting the head)
- 4 mm thread + 1 nut ( for securing Quick release plate + 8x 3D printed bottom)
- 8 mm thread + 2 nuts ( for securing head on tube + 9x for the base plate DXF)
- DXF Files for baseplate: https://www.thingiverse.com/th... (Pinshape doesn't support DXF Files)
if you lasercut the base plate:
- 8x 6 mm threads + nut (can be wing nuts for easy of use or 3d printed nop)
Picture shows where part needs to be relative from each other. (only the printable part are in the picture).
List of 3d printed Parts:
- Balance_Lower_Part (part of head)
- Balance_Upper_Part (part of head)-Bottom_Main
- Bottom_Side (print 2x)-Bottom_Attach ( Glue in 15 mm Tube)
- Centre
- Centre _Top
- Gimbal_Arm
- Gimbal_Clamp
- Gimbal_Clamp_Handle-Handle_Gimbal
- Head_Attach ( Glue in 20 mm Tube)
- Lower_Tube_Holder
- Pipe_Jam_Nut V2
- Pipe_Jam_Bolt
- Quick_Release_Bolt
- Quick_Release_Plate
- Thumb_screw_Nop 5mm (for one the head)
- Thumb_screw_Nop 6mm (for one the head)
- Tube_jammer
- Tube_To_Head
- Tube_To_Head_Small
- Weight_Plate_Nops (instead of wing nuts)
Comments (1)
Sign in to leave a comment.
No comments yet. Be the first to comment!