Description
Folding Batarang based on Arkham game series design. I couldn't find any that looked right. All the ones I found were flat apart from the blade edge, but I used to have a model of one, and I knew that the main part of the wings were thinner, then beveled up and got thicker towards the blade edge.
Assembly is simple, small hole on wing slots over pegs on centre disc, then other disc seals on top. Alternate file for wing has been added which has been split down centre for easier printing.
Anyway, here is my version of the arkham series batarang
Edit: 17/08/18 19:38 - New Centre Top and Centre Bottom files added
Centre Top and Centre Bottom files edited, pegs have been made smaller for better clearance. Outer part has had ring cut removed and now has a raised filleted edge
More from this category
SD Card Flash Drive Holder
by Gpasteve
SD Card/ Flash drive holder that can be mounted to a 3d printer, a desk or a shelf .
Apple Pencil with Smart Cover clips for iPad Pro
by vova_chmarak
Clips for iPad Pro with Smart Cover and apple pencil
Flexible covid ear saver (13 to 24 cm long)
by imakina
Flexible ear saver 13 to 23 cm long. Only 1 gram each piece.
Arduino Pro Mini Holder
by dTom
SummaryUpdate V3, More secure to hold the Pro mini For Plotclock on Note 2 (http://www.thingivers...
Aluhotend fan duct
by misan
SummaryFor a 25mm fan. Tap the the holes with M3 and use M3x16mm screws to fix the fan. Press th...
Comments (3)
Sign in to leave a comment.
When I print a wing, the blade tip falls as it's being built. Is there a way to fix this?
batman dddddddddddddddoooooooooooooooooodoooooooooooooooooooooooo