Toy Airplane

Toy Model Airplane

Easy to assemble and print airplane.  Very little support material required. 

Print Settings

• Suggested Material:PLA
• 50mm/s
• 0.15mm layer height and 40% fill on body parts
• 0.08mm or less layer height, 90% fill on axle and prop shaft
• Support suggested for prop.
• Remove built-in support on bottom part
• 0.06mm 30mm/s, 20% fill for Ninjaflex Tires

Additional Instructions

The model is assembled using off-the-shelf 4-40 screws which can be found at any hardware store.  

4-40 1/4" Screws: 11x

4-40 1/2" Screws: 3x

The tires can be printed from Ninjaflex or similar TPU.  A hub+tire combined part is provided if Ninjaflex is not available.  In this case, print the Hub_Tire part in regular PLA.