Two-Wheeled Rover

This is a remote control vehicle, powered by a LiPo battery and two 730 RPM gearmotors from Servocity (#638260).  The wheels and structure are all printed without support, and are held together with #10 hardware (the gears attached directly to the motors are an exception, and use 8-32 screws).  The wheels are driven by gears from the motors, and are constrained by the Motor-Wheel Clamps with a clearance of 1 mm for clean rotation with aligned layer lines.

Printed Parts required:

• x1 Battery Housing
• x1 Controller-Reciever Housing
• x2 Hub Mounted Gear
• x2 Wheel
• x2 Motor-Wheel Clamp
• x2 Motor-Wheel Clamp Mirror

Non-printed Parts required:

• 2x5 Sabertooth Motor Controller
• LiPo Batter (7 cell used as shown)
• RC controller/receiver (Standard for RC planes)
• x6 #10 Screws, 1.5 inch
• x8 #10 Screws, 0.75 inch
• x8 #10 Screws, 0.5 inch
• x22 #10 Nuts, any type