Description
Mechanical Adjustable Iphone / Ipad Stand
the stand is designed to hold phone or tablet. I tried the stand for IPAD PRO and IPHONE. Print each piece per piece per file, except the toothed wheel - 2x. For composition you need axes, I use 2mm polished mtb wire. cut lengths: 7mm, 24mm, 28mm, 38mm, 57mm
Right Knob serves as angle change, Left as a lock
How to make:
as picture describes
More from this category
Smart LCD Case Stand Alone version
A stand alone LCD case for the RepRap Smart LCD with SdCard reader
SD Card Flash Drive Holder
by Gpasteve
SD Card/ Flash drive holder that can be mounted to a 3d printer, a desk or a shelf .
Apple Pencil with Smart Cover clips for iPad Pro
by vova_chmarak
Clips for iPad Pro with Smart Cover and apple pencil
Flexible covid ear saver (13 to 24 cm long)
by imakina
Flexible ear saver 13 to 23 cm long. Only 1 gram each piece.
Arduino Pro Mini Holder
by dTom
SummaryUpdate V3, More secure to hold the Pro mini For Plotclock on Note 2 (http://www.thingivers...
Comments (3)
Sign in to leave a comment.
The base is missing the support bosses for the 57mm shaft. This design, as posted, will not work.
Unless it has been decided that the helical set does not require a fixed pivot point (axel), this assembly will not work as posted. The support bosses for the 57mm shaft are missing from the "Base" .stl file. I use Fusion 360 where it is very difficult to convert an .stl to an editable component. Otherwise, I would correct this part for you.