Dish Drainer Cup

Mother broke her dish drainer cup, heck why not make a new one and beef it up a bit.  Added ribs around the edge to reduce failure probability from horizontal forces (hitting the cup from the side while in a hurry).  The uneven line on the cup is due to a power surge and having to continue the print post glitch.  Recommend good adhesion to build surface for supports (I printed with drain slots touching the surface)

Settings:

PLA 200C, Bed 60C

ABS (didn't test but should do fine as well, would provide more longevity with water)

Infill 20%

Supports: Yes, recommend a build plate adhesion for the support under the hooked area, & properly leveled bed with good nozzle retraction.

- 81 Deg. Overhang recommended. <45mm/sec on speed for supports, rest can be 45+.