My Penis

thank you nuclear spike for you in-depth data on the D

😐🤐😯

For anyone interested: I've printed this model several times with various settings.

I've discovered that if you turn on "tree support" at 70% that it will only print a *tiny* amount under the balls to make sure they print. Otherwise it prints a ton of extra supports that aren't really needed. You can also turn off infill! That's right! This model will print hollow no problem, at least when I had it on .12mm layers. Larger than that may cause issues, I don’t know. I've printed using heat-reactive filament with 10% infill with .2mm layer, but also with glow in the dark & hollow at .12mm, transparent & hollow at .12mm, and a speckled version where it's hollow and .12mm but certain parts are black-light reactive.

As for analysis of the D, he’s *exactly* 7” from the base (before it blends into the sloped base to hold it) to the tip (as long as you don’t drag the ruler over the curved tip to reach the “tip” (or you gain an extra .5”). When the fabric ruler is held tight and away from any curvature, you get a nearly perfect 7” measurement. The circumference around the the printed model is precisely 5” and doesn’t change anywhere you measure along the shaft (excluding head obviously). It’s very balanced. If you measure more than 7" then your own measurements are likely inflated by at least .5" since you're including the curvature as part of the length and length shouldn't include any curves! Just a straight line!

In terms of aesthetics, having a non-curving, non-twisting, normally proportional sizing of head vs shaft, etc, this model comes in nearly 100% of ideal for proportionality. It’s literally 100% straight out from the base with a head that is proportionally perfect for the thickness and length of the shaft.

As for abnormalities, in my experience it’s unusual for the slit (meatus) to not be at the tip. His is along the underside. I don’t know how that affects his loads but I’m guessing they don’t shoot straight out and hit the ceiling, but more that they’d cause his lower body to get covered, but I don't know! Maybe even being positioned below the tip it still shoots out fully straight into the air just like everyone else, who knows? Also, his balls are very high and tight compared to others out there.

Even if you’ve never thought to hold a stranger's D, it’s an unusual experience see how it feels in your hand. It ain't gay because it's just plastic, bro. What does a perfectly straight 7"x5" D feel like without asking your best friend to find out? Printing hollow with .12mm layer height takes about 9 hours on my Ender 3 Pro.

(deleted)

Say, if I were to print this, and then put it in my ass, would that make you gay, as your penis has technically been inside another man

Looks perfect :OK: