Description
This "screw-free" housing encloses the DHT11 temperature and humidity sensor with its four jumper cables.Β The lid is optimized to snap into place perfectly, so there are no screws needed. However there is a lowered hole for a screw to attach the case somewhere.
Printing settings:
- 0.3 mm layer hight
- 60 mm/s printing speed
- retraction ON
More from this category
Smart LCD Case Stand Alone version
A stand alone LCD case for the RepRap Smart LCD with SdCard reader
7 β€οΈ
2 π¬
1 β¬οΈ
Free
SD Card Flash Drive Holder
by Gpasteve
SD Card/ Flash drive holder that can be mounted to a 3d printer, a desk or a shelf .
0 β€οΈ
1 π¬
0 β¬οΈ
$0.5
Apple Pencil with Smart Cover clips for iPad Pro
by vova_chmarak
Clips for iPad Pro with Smart Cover and apple pencil
1 β€οΈ
1 π¬
0 β¬οΈ
Free
Flexible covid ear saver (13 to 24 cm long)
by imakina
Flexible ear saver 13 to 23 cm long. Only 1 gram each piece.
1 β€οΈ
1 π¬
0 β¬οΈ
Free
Arduino Pro Mini Holder
by dTom
SummaryUpdate V3, More secure to hold the Pro mini For Plotclock on Note 2 (http://www.thingivers...
5 β€οΈ
2 π¬
2 β¬οΈ
Free
Comments (1)
Sign in to leave a comment.
No comments yet. Be the first to comment!