This is a redesign based on the Disneyland Japan Mickey Shaped Soap.
I made this Adaptor to fit on any standard Bath and Bodyworks foaming soap pump dispenser.
I recommend printing in on an SLA resin printer, but Just keep in mind that if you print in on a FDM printer, thake shure that is water proof.
Is verry important that you dont change inside mesures, that need to be more simetrical as possible.
Make sure to place supports only were that you can reach and remove or it will not work. Tip, use a curve tool to pull the supports out through the three holes at the bottom.
If you are having problems to take out those supports, try to print the arquives "Half - Bottom" and "Half - Top" and join the two parts with glue.
Loading prints...
MICKEY SHAPED FOAMING SOAP ADAPTER TO BATH & BODY WORKS
Creative Commons Public Domain
The creator has waived all rights to the work. You can copy, modify, distribute and perform the work, even for commercial purposes, without asking permission.
Licensed under CC0
Loading comments...