,Yet another towel holder.. but this time with clear hygienic signs to avoid mixing up the towels intended for your face, hands and body – ladies and gentleman’s.

Use double-sided tape to mount on your ceramic tile wall.

The face-, hand- and bodyholders comes in two variants – with a regular hook or with a “claw” preventing the towel to slip off when pulled in an angle upwards. The claw design needs support from 45-degree overhang. Remove the support with a needle pliers.

Just fuse the suitable pieces together in your 3D-printer software, rotation of the pieces when you import them may be necessary.    

For best results when 3D-printning

• Use a layer height of 0,1mm.
• Suitable printing materials: PLA tough or regular PLA.
• If your printer has build plate adhesion problems, use a brim.
• Scale it after your needs, original height: 65 mm, width 40 mm.