I designed this end for the TUSH ultimate spool holder to keep it from toppling over. It fits nicely if your dimensions are dialed in.
http://www.thingiverse.com/thing:2047554
The 57mm version is meant to fit a spool with an average width of 57mm. (SUNLU) The 47mm version is meant to fit a spool with an average width of 47mm. (PolyFlex)
Make two, one for each end. I printed this with PLA, layer height of .2mm, and 20% infill.
The file SpoolPad.stl is for the bottom to prevent the rollers from sliding on the table. Print this with TPU and hot glue it to the bottom to keep them from sliding.
Loading prints...
Ultimate Spool Holder Holder
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...