Spread the load / increase fixing area when mounting insulation/plasterboard with screws. 60mm Diameter.
TIP: Print without supports by moving 1mm below the build plate (z-axis -1mm).
There is an additional 1mm deep notch on that side that faces to insulation, this adds even more support like most retaining clips. However, it becomes more difficult to print, so far I've never needed it. Printing at 0.2 or 0.3mm doesn't seem to affect practical usage.
Loading prints...
Insulation Load Spreading Retaining Washer
1
like
0
collections
Tags:
Creative Commons Attribution-NoDerivatives
You can download, share, and use commercially, but you cannot change the material in any way or use it to make something new.
Licensed under CC BY-ND
Files Included
1 downloadable file:
Free download - login required
Downloaded: 28 times
Downloaded: 28 times
Loading comments...