I was looking at all sorts of filament guides. I found one that required drilling into the frame of the printer. I tried that, but the metal was too strong for me. That's why I modeled a clip-on filament guide. For this to work best, you should file down the plastic ends on the bracket. This originally had only one "arm" and was attached to the machine using double sided tape. It wasn't strong enough so I added two "arms" and a clip-on system. Lastly, I recommend you print this at .1mm layer height with 50+ infill (the higher the stronger) for the best outcome. This may fit on similar printers, but I haven't tested that aspect of this, yet.
Loading prints...
Wanhao Duplicator i3 Clip-On Filament Guide
Creative Commons Attribution-NonCommercial-NoDerivatives
You can download and share as long as you credit the creator, but you cannot change the material or use it for commercial purposes.
Licensed under CC BY-NC-ND
Files Included
1 downloadable file:
Downloaded: 21 times
Loading comments...