Spoiler/wing to bolt onto the back of a Traxxas Rustler body. Just a quick design after ripping an old rear wing off. The picture is of V2.
It does require different screws from the stock ones though. I had some 1/2 inch #8 machine screws laying around that I used on it.
V1 was my first attempt, but eye balling the angle at the back of the body was a bit off so it seems to lean back a bit.
V2 corrects the issue of the angle being bad. As well as better countersinks for screws. Not real sure when it is flipped in the STL compared to V1, but I flipped it 180 degrees and printed it flat there on its back.
Loading prints...
Traxxas Rustler Wing
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Files Included
2 downloadable files:
Downloaded: 42 times
Loading comments...