The only post process needed is to round the camera screw hole with a 13/64" bit and then make the threads with a 1/4"-20 bit.
I also had to file down a bit of the plastic at the back for the camera wire to slide in correctly. This is due to printing without supports but it works fine.
Loading prints...
Tripod PS4 VR camera holder
0
likes
0
collections
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...