**Disclaimers**

- All non terrain models in pictures are of Games Workshops Intellectual Property.

- This is my first full design set.

- All prints have only been done on a filament printer, at this point in time I have no info on how well it will print with resin.

Thank you for looking at my first design set! This modular terrain will help you play out your tabletop games with an Egyptian feel. The goal was to have a design that would be reminiscent of how some Egyptian buildings would look in a non ruined state closer to the time they were built. I went with simplicity as much as I could, and I hope you enjoy it in your siege battles and other campaigns like I will. 

All terrain is painted as follows:

• Base coat white spraypaint
• Base layer Citadel Screaming skull
• Light wash with Citadel Agrax Earthshade
• Dry brush with Citadel Eldar Flesh

I look forward to pictures and feedback if you decide to buy this product!

All prints were with the following specs unless otherwise noted:

Printed on Creality Ender 3 Pro

All models should be rotated correctly to how I printed them. Almost all are support free, a few are pre supported.

Sliced in Cura with following settings (can use the standard setting for .2mm layer height, and adjust the specific settings below):

• .4 mm nozzle
• .2 mm layer height
• 7% infill, line pattern
• 30 mm/s speed
• ironing on (I) or ironing off (NI)
• Brim bed adhesion (Brim) (optional on all, needed when noted)

This is the following breakdown of each piece, material weight, and time:

Walls

• Ankh with chariot             171g  27:44  (NI)
• Winged Sun with soldiers  171g  27:08  (NI)
• Straight Plain                   168g  25:58  (NI)
• Corner Wall                      100g  15:15  (NI)

Obelisk                 31g  6:08  (I)

Obelisk Damaged  31g  6:04 (I)