wanted to make the closest replica porsche sim wheel i could so in looking for a gt3 knob, i couldnt find a satisfactory knob like the ones i have seen on the steering wheels- so i made and have shared one here. this will fit any 6mm thread potentiometer knob. otherwise a bit of sanding or drilling will allow any to fit.

There are included two types of knobs- the full knob with a outer bottom plate base- and one without. As you can see in the photo- the knob without the plate is to allow vision for the settings dials underneath.

The filling is to be printed seperately to allow for ease of painting in a different color. If it dosent sit as low as you would like, again simply sand the bottom.

Finish with gloss black for main and red- blue- yellow -pink for inner . email me at lmike.s1mulakra@gmail after purchase and i ll send the sticker file for the background dial graphics.

3D PRINTING SETTINGS

super quality 0.12 70-100% infill layers 4 walls 3-5 supports: yes

Use 150, 400, 600 then 1200 sandpaper And finally primer filler and paint !