Hi Makers, I present my new Overwatch themed standphone, decorate your gaming room with an appropriate standphone.
I’ll give you a couple of tips on the press, first of all the written print at 0.10 resolution and at a very low speed, so it is small, it will not waste much time, the stand always at 0.10 or maximum 0.15, at a speed higher than the writing.
Use simple PLA, or if you want more strength, PETG is very good, on temperatures, I can not give you general advice, because you will have to respect the temperatures of your supplier.
Use uniposca colors, to have a colored effect.
If you liked the design, leave a like and share it on your social media, I also thank you both if you buy it at the reasonable price of a coffee, but even just xke you stayed to admire my design.
"If you have any ideas, propose anything, I will try to achieve whatever you want, always relying on my abilities."
Thank you very much makers.
3D PRINTING SETTINGSLayer 0.10 max 0.15 Infill 10/15% Top and Bottom Layer 4 Perimeter Layer 3 Support"View picture"
Loading prints...
Overwatch StandPhone
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Loading comments...