Need to make your Flux Capacitor authentic?
This is an almost exact design of the original Flux Capacitor case from the BTTF movies. J1210JPL Stahlin case, with front cover cutout. Also the backer board for mounting the component parts is also included.
Inspiration from these websites:
https://www.therpf.com/forums/threads/bttf-flux-capacitor-replica.330326/
https://markus-wobisch.blogspot.com/2018/12/building-bttf-flux-capacitor.html
(done 14 July 2023) I will eventually upload a cut up version of all the parts, so smaller printers can make this case....
Size: 291mm x 345mm x 177mm
When the hinge is printed use a 5/64 inch drill bit (6 inch long) to clear out the hinge pin holes then use 1.75mm filament as the hinge pin... Do the same for the latch assembly pins..
I am also in the process of designing the interior parts from original drawings and specs.
Loading prints...
BTTF Flux Capacitor Complete Case and parts board
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Loading comments...