NOTE This is a Work-in-Progress Page.
DO NOT PRINT THE STL*s yet!
The Complete Project will be totally Open Soure with BOM,Firmware,Config and so on. Just a little bit of patience. Some of you guys did already ask if we are going to Sell this Printer as a ready to go finish kit or even a fully assembled Unit.
Yeah, there will be Pre-assembled Kits in the Future. If you want one, make sure to check our Website for the latest News. www.ingenium-3d.xyz or check us out at Insta: @ingenium3dgermany
SPECS Printing Area 300mm x 400mm x Infinity
X & Y Nema 17 Closed Loop Position System
24v Phaetus Dragonfly Allmetal Hot-End up to 500degree Celsius with Special Airbush Point Nozzle
Dual-Gear Extruder Capricorn PTFE Tube for Filament Guiding decentralized Berd-Air system for Part cooling Heated Bed up to 90gedree Celsius
Glass-Fiber Woven GT2 Timing Belt Meanwell 24V/350W Power supply
Composite Material Printing Conveyor Belt - Look at our Shop - We are using our own developt Mesh-textured Belt.
BigTreeTech Octopus V1.1 32Bit Mainboard BigTreeTech Mini 12864 Display TMC2209 Stepper Driver Filament Runout Sensor Webcam with 5MP and a 1080P resolution
MGN Linear rails for X and Y in a Stable and very sturdy XY core Configuration
Firmware Klipper with mainsail as GUI on a Rasphberry PI
Loading prints...
INNOBELT - Affordable Conveyor Belt 3D Printer - Open Source
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Loading comments...