This party gadget is perfect to get all views on you! You can fill 6 shots an the same time. The video is from my bigger shot filler with 8 arms. Its measurements are dont for simple plastic shots you can buy everywhere (around 45 mm heigth). Its done out of to parts - the filler & the foot which then can be stuck into each other. Here i had to do some polish to fit the parts easily together.

Parameters: Shot: upper diameter = 40 mm, lower diameter = 28 mm, height = 45 mm Filler: Foot outer diameter = 170 mm, Foot height = 65 mm Filler outer diameter = 156 mm, Filler height = 93 mm

I have no print for that but it is totally common to my eightfolds shot filler.

3D PRINTING SETTINGS

I have no print for that but it is totally common to my eightfolds shot filler.

First of all i want to mention that i have a selfbuild Reprap printer, so for commercial one I have no experience if printing is going well. I did top, bottom with 2 layer (0,4mm) and walls two surroundings(0,8mm). Infill was 15%. I was using for the Filler Brim, and you have to care for the cooling due to Curling on the arms. The foot is very easy. If it is not fully waterproof after printing you can use glue to close the problem areas - i did this aswell.