this is a simple bowden arm for a kossel, the spring cup diameter is 11mm. you can use a bearing but i suggest a v-wheel and a small piece of tube to keep the filament brom binding. i used a small pice of carbon tube. the force applied to the spring cup is doubled on the wheel and can safely go up to 30lbs. you may also need a washer or two between the peg and the motor.
Loading prints...
kossel 2020 bowden arm
1
like
0
collections
Creative Commons Attribution-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given and your contributions are under the same license.
Licensed under CC BY-SA
Loading comments...