This pack consists of 5 distinct characters. Lumiere, Cogsworth, Mrs. Potts, Chip and Plumette from 1991's Disney's animated movie Beauty and the Beast.

Lumiere The complete dimensions for Lumiere are the following (mm):

Height- 335

Width- 240

Depth- 126

There are two versions available. In the first one, you will have holes in the candles for you to be able to use electric candles in them. In the second version, the candles have no holes in them, and the flames are included in the sculpture (to be painted, for example).

The electric candles used have the following dimensions (flames are not included in these dimensions since they should be above the hole for full effect):

Height- 28 mm Diameter- 36 mm

DISCLAIMER: Do not use real candles due to fire hazards.

Cogsworth The complete dimensions for Cogsworth are the following (mm):

Height- 240

Width- 121

Depth- 68

Mrs. Potts The dimensions for Mrs. Potts are the following (mm):

Height- 160

Width- 186

Depth- 208

Mrs. Potts Hat

Height- 549

Width- 130

Depth- 130

Chip

The dimensions for Chip are the following (mm):

Height- 798

Width- 766

Depth- 984

Plumette The complete dimensions for Plumette are the following (mm):

Height- 248

Width- 158

Depth- 145

Note: The string shown in the render screenshot is not printed. To achieve this effect, you should add a real string to the appropriate hole in Plumette's head.

Sculpting software used: Blender

Render method used for the previews: Cycles

Filament: PLA

Slicer used to 3D print: Ultimaker Cura

Settings I've used to 3D print:

Standard quality - 0.2mm

Infill - 20%

Supports  Lumiere - I've only used supports for Lumiere's nose. The rest should be safe enough to print without them. Cogsworth - You can print this piece up or lay it down, depending on your preference. Standing up (printed by default), needs some supports on the chin, arms, and body interior. Mrs. Potts and Chip - I've used supports for their "nose" and for the hanging parts of the hat. Plumette - This might depend on your printer settings and skills. So, you can have supports for the head or no supports at all.

Speed - 50% first 20 layers and 100% for the rest

Plate Adhesion - Skirt

Cooling - Enabled

Travel - Retraction Enabled