This case holds the Raspberry Pi model 2 micro controller. The top slides and snaps into place (see directions at bottom).
Full Story: http://www.mkrclub.com/2016/01/a-fancy-3d-printed-...
Directions for fitting cover on base: - Slide the bottom of the raspberry cover into the slots in the base and then click the top of the raspberry down into place. This should hold snugly, but there are also screw holes if more firm cover is needed.
Loading prints...
Raspberry-shaped Raspberry Pi Case
153
likes
49
collections
Creative Commons Attribution-NonCommercial-NoDerivatives
You can download and share as long as you credit the creator, but you cannot change the material or use it for commercial purposes.
Licensed under CC BY-NC-ND
Loading comments...