This is my first attempt at an iPhone 6/s case. It is a simple triangle design with some over layered bumpers that cover the entire edge of the phone.
Note: I recommend increasing the infill settings at 100% to increase the strength of the iPhone case.
My Configurations Settings: (may vary since these are my settings )
Slicer: MatterControl
Printer: Wanhao Duplicator I3
infill setting: 100%
Layer Height: 0.1mm (0.2mm look looks okay as well.)
Raft: Yes (but not recommended)
Print ETA Time: 4 Hours 35 Minutes
HeatBed: yes (not recommended )
--- Support 3D Creator ---
If you would like to help me create more cool things and remake stuff, or buy me coffee that would fuel my creativity to do so, you can by clicking here .
Loading prints...
Triangular Iphone 6/6s Case
Creative Commons Attribution-NoDerivatives
You can download, share, and use commercially, but you cannot change the material in any way or use it to make something new.
Licensed under CC BY-ND
Loading comments...