SummaryThis is a remix of the great "Tripod mount for GoPro Hero 3+ Black with LCD" by lucibrandus: http://www.thingiverse.com/thing:903018 But the difference is - this is for a bare GoPro (without LCD), so it's less deep. I just shortened it, so please don't give me any credit :). The tripod screw hole is un-threaded, but it's very easy to make the thread. Warm up a 1/4 inch tripod screw on a gas hob, or put it inside hot water, and screw it in gently. Let it cool, support while it's cooling. Unscrew. I warmed it just a little, so I can still hold it, and screwed it with force. Clean, good thread.Print SettingsPrinter: CreatornatorRafts: Doesn't MatterSupports: Doesn't MatterResolution: AnyInfill: 100%Notes: You can print this however you like, it's a very simple part. I printed in PLA at 100% density (no infill just perimeters) and some supports, at 0.2mm layer height, 20mm/s, side down.