SummaryAre you also doing your dishes by hand? Well I do and i got really tired of drying my cutlery by hand and i had nowhere to place them... So I designed this elephant, inspired by Peleg Design. It uses a channel and angle on the inside to let water flow outwards from the snout of the elephant. Prints best with solvable materials (PVA + PLA for example). The inside is OK without support, but the legs are right now a mess to remove PLA if you use only 1 extruder. I will update this shortly! https://www.youtube.com/watch?v=txySkuefKJEPrint SettingsPrinter: Flashforge DreamerRafts: Doesn't MatterSupports: YesResolution: 0.1-0.3Infill: 10-15Notes: You can use a single extruder and get good result! I printed with Orbi-tech PVA as support material, solved in cold water overnight.Post-PrintingClear coat = waterproof Using 2-3 layers of clearcoating (quite excessively on the inside) the model is fully waterproof and all the water left on the cutlery, channeling it out from the snout.How I Designed ThisDesigned using 3ds Max Custom SectionSee how everything was made!