This is a boomerang based on the Batman logo that will (hopefully) return, I haven't actually tested it though in theory it should work. It has had over 150 downloads and no complaints so I presume it works.
This website shows you how to throw a boomerang http://www.wikihow.com/Throw-a-Boomerang.
The model is in one piece (at least when you print it :) ) dimensions are approx: 250x80x2.5 (mm) and can be printed without supports.
The lighter you print the boomerang (lower fill) the easier it will be to use (using about 10%-15% should be fine).
It will take around an hour and a half and use about 3.5 m and 10g of filament.
The outer corners are blunted to prevent damage to people or property.
There is a right hand model and a left hand model.
Loading prints...
Returning Batarang
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Files Included
2 downloadable files:
Downloaded: 556 times
Loading comments...