The dark side and the light side are just two sides of the same coin, right? At least they are in this case.
This is a simple modular coin design that consists of 3 parts: 1 rim and 2 inserts. I have included a blank for remixing or gluing your own designs to the coins as needed. The finished coins have a 36mm diameter and are 4mm thick.
The inserts are just the right size to snap into the rim and stay in place. When installed, the inserts have a little bit of play. This was to allow for various printer capabilities. If you don't like the bit of wiggle room that is left, you can put a small piece (or two) of standard office paper in between the inserts to get rid of the movement.
If you print this, be sure to share and tag @andrewbougie on Twitter and Instagram. I love to see what others do with my models!
Print Settings
- Printer: Printrbot Simple Metal
- Rafts: No
- Supports: No
- Resolution: 100 microns
- Infill: 25% or solid
Notes: I printed these in PETG which may make it easier to snap the inserts into the rim without breaking them. It should work fine with ABS or PLA, though.
Loading prints...
Star Wars Coins - Modular Insert Design
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...