Show your Batman pride with this Batman phone stand! This two piece phone stand is very easy to print, because there aren't any supports or bridges to worry about!
I printed this (with PLA) with these settings:
Speed: 40 mm/sec
Infill: 20%, honeycomb pattern
Layers: 0.3 mm each, 0.4 mm for first
Bridging or supports: None!
Filament settings will vary by filament. I use Inland's red and yellow PLA filament. Here are the settings I used:
Temperature: 220 C
Bed temperature: 57 C
Post-printing:
My printer can't print very high quality, so I had to use a finishing tool to smooth out edges and make some of the holes a little bigger. I bought a really cheap one, but does the job well: http://www.modifi3d.co.uk/
***The phone used for this print was an iPhone 6, so I don't know if larger phones can fit. If they don't (which they probably won't), just scale the file larger, maybe 105%.
Loading prints...
Batman Phone Stand
Creative Commons Attribution-NoDerivatives
You can download, share, and use commercially, but you cannot change the material in any way or use it to make something new.
Licensed under CC BY-ND
Files Included
2 downloadable files:
Downloaded: 244 times
Loading comments...