I've always struggled with GoPro mounting designs... takes too long to adjust/mount. Hopefully, this design makes it quick to change the location of your GoPros, from the handlebars to the seat-post as quick as you can.
Idea: only one piece design. Print 2 for a complete setup. Theoretically, the two pieces will match up and "CLICK" or "SNAP" lock into each other. To release, grab the indented finger tabs at the top and bottom, and pull to release. Use the original GoPro hardware. Ability to mount 2 GoPro's, facing in opposite directions to capture all the action!
For now, this is suitable for round tubes/bars that are 7/8" diameter. Since I haven't actually printed one myself, I cannot suggest the best way to print. I would probably assume that a a good amount of FILL will make this stronger.
Option for single GoPro, there's a 2nd part for single GoPro mount ("Plain.stl")
Loading prints...
Dual GoPro Bicycle / Motorcycle bar mount
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Files Included
2 downloadable files:
Downloaded: 133 times
Loading comments...