SummaryThese are trap door floor parts for use in the OpenForge 2.0 Wall Construction Kit. Go there to understand how these are to be used. I strongly recommend printing the trapdoor with the upright file, as you get way better detail on the wood grain if it's printed on the z axis. If new trap door floor sizes get made in the future, I'll update this thing with the appropriate pieces. OpenForge is now a patron supported project. I use the resources that my patrons give me in order to get the resources to let me create more sophisticated tiles with a greater level of detail. Please, support me, and I’ll deliver an ongoing stream of awesome gaming terrain.Post-PrintingAssemblyUnderneath the floor tile, there is a divot for holding the hinge. Straighten and cut a paperclip to fit that divot and then slide it into the hole on the side of the trapdoor. Depending on how well your printer does with bridging, you may need to use an xacto to clean up the divot and a drill or pin vice to clean out the hole in the trap door. Place the trapdoor in place in the floor tile, with the hinge running through it. Place any magnets you want to use in the base. Use cyanoacrylate glue (superglue) to glue the floor to the base, trapping the hinge. Note: the metal hinge will draw the magnets, so you want to slap the floor onto the base pretty fast or it can create a little bit of a mess.