Lipo batteries are volatile and can be explosive if damaged, They are also very expensive so protecting my investment and avoiding damage in a crash of my drone is the concept behind this design. It had to do the job but also be as light as possible and have ventilation to avoid overheating. This was printed on a Makerbot Replicator 2 without supports or special settings in PLA. This is an original design. The two higher sides on the longer part of the holder have a slot where a velcro strip is looped to help hold the battery in place. There is a recess in the rear the battery slips into to avoid any slipping around and facilitates quick and easy removal.
Loading prints...
Glacier Lipo Battery for DJI Drone
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Files Included
1 downloadable file:
Downloaded: 48 times
Loading comments...