For prototyping electronics sometimes you need to use alligator clips to help make the circuits. But what do you do with them after? They can easily get tangle up in a pile or lost individually. Therefore, I've made this neat little gadget to hold the alligator clip.
What you do is place one in of the wire in the part that is just big enough to slip the wire through. This will anchors the alligator wire in place. Then using the triangles sections you wrap the alligator wire around three times. And finally securing the wire on the other side's clip.
To print this I had used PLA with 25% infill and 0.3 mm layers. For my printer I need to use 25% infill to get rid of pillowing on the top layer. So you might can use less or need more accordingly.
Loading prints...
Alligator Clip Holder
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Files Included
1 downloadable file:
Downloaded: 34 times
Loading comments...