Basically you mount this to your dustpan so that after sweeping, you can run your broom's bristles over the "teeth" to wipe off the remaining stuck-on debris.
I would recommend printing in ABS with 100% infill, for strength and flexibility. I had to bend mine a little for it to fit. It might have otherwise snapped with a low infill (or using PLA). I used .3 layer height, with a raft.
The length is about 7 1/2 inches x 1 1/2 inch in depth. Scale as necessary depending on your dustpan's size. Three holes were added for the screw mounts, but you might have to drill them slightly larger (not too large though or it will crack). I used screws with a washer and bolt for added security, rather than just a screw by itself.
Loading prints...
Dustpan broomstick wiper
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Files Included
1 downloadable file:
Downloaded: 54 times
Loading comments...