Cover this with aluminum foil and lay over your Wi-Fi router's antenna. Print 2-3 if you have more antennas on the same router.
Measures: 2 inches wide 1 inch in depth 3 1/2 inches high
Pretty small but you can widen out the foil on each side by overlapping the top. OR make it higher by overlapping the sides.
I used PLA w/.3 @ 5% infill.
**I've added a 2nd .stl file with a brace on the bottom which may keep it more stable resting over the antenna.
***May also be used on an old fashioned radio as the pictures show.
Loading prints...
Wi-Fi (or) transistor radio signal strenth booster
1
like
0
collections
Tags:
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Loading comments...